RK500-06LC
Liquid Cooling ORP Sensor

Platinum ring electrode

Designed for online ORP measurement in oxidizing and reducing environments. Internal signal isolation helps reduce electrical interference.

Detailed ORP readings

Measures from -1500 to +1500 mV, with a specified accuracy of ±1 mV and a resolution of 0.1 mV. The specified response time is 14 seconds to 98% response in flowing liquid.

Two outputs at the same time

Simultaneous 4-20 mA and RS485 outputs connect to compatible monitoring equipment. The sensor operates on 7-30 VDC and consumes less than 0.2 W.

Choose a stable flow location

Install on a bypass pipe for easier maintenance. Choose a location with steady flow and no obvious turbulence. Vertical upward flow is preferred; a suitable horizontal pipe is also acceptable.

Keep the ORP sensor at least 15° from the horizontal line.

Keep the sensing area clear

Avoid high-point gas traps, low-point sediment zones, vertical downward flow and positions downstream of pressure-reducing sections. Bubbles and deposits can affect readings.

For the M16 connector, leave at least 70 mm of cable outlet clearance to prevent excessive bending.

Before use

Remove the protective cap in front of the electrode before placing the sensor into service.

When not in use

Soak the electrode in 3 mol/L KCl solution or saturated KCl solution.

Do not store it immersed in distilled water, deionized water or tap water with very low ion content.

Routine cleaning

Follow the cleaning procedure in the product specification for the type of contamination present.

The specification recommends cleaning with tap water every 6 months, according to the working environment.